The scope of this project was to supply the relevant calculations required to verify compliance, of 12 equipment: 8 pressure vessels and 4 S&T heat exchangers, with the current edition…
The mechanical calculation of the shell and bottom as per ASME VIII Div.1, nozzles, tubing and flanges, connections and lifting devices, loads verification as per WRC 537 and the welding…
The objective of this project was to verify two components of a vertical pressure vessel. The jacket had a discontinuity where there was a pipe with a blind flange, so…
Mechanical design and calculation of seven (7) vertical pressure vessels (filters), according to the EN13445 standard. The analysis of all components (heads, shell, nozzles, skirt, saddles, anchor bolts, etc.) has…
Due to the remodeling of a food production plant, it was necessary to modify the routing of the heating and cooling piping systems. The project consisted of the analysis of…
The project consisted of the mechanical design, static calculation, fatigue evaluation and development of manufacturing drawings for five (5) ASME Stamped pressure vessels. The corresponding UDS (User design Specification) and…
For the replacement of the floating roof of an existing storage tank, the roof calculation (buoyancy + stress analysis) and the roof fabrication drawings were developed, according to the API…
Verification of two supports of the new Water Deluge System for the Propylene Polymerization unit, Tarragona. A mechanical calculation was performed to determine the seismic loads induced in the supports…
The purpose of this project was the analysis of the proposed routing, location of supports (fixed points, guides, springs) and stress and flexibility analysis for three Steam CS lines (8”…
The purpose of this project was the analysis of the proposed pipe routing, location of supports (fixed points, guides, springs) and stress and flexibility analysis for an 8” NPS carbon…
Pressure vessels under study are 2000 and 2700mm diameter and 4950mm and 5000mm TL-TL, made of SA-285 Gr.C and SA-516 Gr. 60 respectively. The verification of these equipment has been…
Stress and flexibility analysis of ten (10) large diameter GRP piping systems as per ISO 14692; these systems range from DN 1900 to DN 600, and are part of a…
Supports verification for the valve’s manifold of the new Spray Water Dilution System, fire protection of the Compressor PV-C-1, in the La Rábida refinery, Huelva. A mechanical calculation was made…
Verification of 5 piping Structural Supports, Welds and Anchor Bolts. The calculation was made based on the loads transmitted to the supports, obtained from a stress and flexibility analysis (also…
The S&T Heat Exchanger is 4.6m in diameter and 15m high, material 1.0425 (EN 10028-2 P265GH). The calculation and verification of this equipment has been made using PVElite, except for…
Detail engineering for the fabrication of three biphasic separators, SG-100, SG-101 and SV-106. The vessels were skid mounted. The scope of the project included from the design of the vessel,…
Design and calculation of a pressure vessel subjected to internal pressure made of aluminium, material EN AW 5083 H-111, 16 barg of design pressure and 60º C of design temperature.…
Design, calculation and drafting of the anchor bolts of a Storage Tank fabricated in Carbon Steel, material SA36, operating at atmospheric pressure and 55º of design temperature. The calculation of…
Design, calculation and drafting of two storage tanks manufactured in Carbon Steel, material A-36 and A-285 Gr. C respectively. The tanks operate at atmospheric pressure. Calculations according to the API…
