The objective of this Project was to carry out the basic mechanical predesign of a 6000 m3 LNG bilobular tank to be installed inside a LNG Bunker Barge, for budgetary…
At first, the idea of this project was to replace a BEU Heat Exchanger, used to heat up ammonia, with a similar one, but then it was decided that it…
The project consisted of the design of a Shell and Tube type cooler. Gas circulates on the tubes side, which arrives with a temperature of 900ºC and a pressure of…
The purpose of the project was the mechanical design and calculation of two shell and tube heat exchangers, for the replacement of existing equipment. The analysis of all the components…
Pressure loss analysis in the hot smoke duct. The analysis was carried out based on the roughness of the internal material of the ducts (refractory), the composition of the combustion…
Verification of a Shell & Tube Heat Exchanger with electric Bundle, due to new operating conditions (temperature increase). Manufactured in A-336 Gr. 6, operating at 99.3 barg and 54º C…
The system consists of two parallel pipelines of 3” Sch10 that run from the base to the top of the Fumes Tower, whose expansion (70mm) generates a leakage problem in…
Design and calculation of a pressure vessel manufactured in Carbon Steel, material SA-516 Gr. 60, operating at 8.1bar of pressure plus total vacuum and 150º C of design temperature. Calculations…
Design and calculation of a pressure vessel, Carbon Steel, material P265GH, 16 barg design pressure and 60º of operating temperature. Material selection, equipment design and calculation according to EN 13445…